Who Handles Roof Leaks After Solar System Installation in Ipoh?

Start with the leak you can locate safely

The first useful check is usually indoors. After heavy rain, look at ceilings directly below the array, roof valleys and places where pipes or air-conditioning lines pass through the roof. Photograph any damp patch, note the room or warehouse bay, and record whether it appeared during wind-driven rain or continued afterwards. A bulging ceiling or water near a light fitting needs prompt attention; keep people clear and don’t touch wet electrical fixtures.

For a simple routine, check the interior ceiling below the array once a quarter and again after a storm that causes a leak. Keep the same camera angle for each photo so you can see whether a stain is spreading. Don’t climb onto a wet roof to look for the entry point; tiles, metal sheets and algae-covered surfaces can all become slippery.

• After heavy rain, note the room or bay, the stain’s position and whether it is actively dripping.
• Photograph the affected ceiling and record the date before the mark dries or changes.
• Keep people away from sagging ceiling material and get qualified help if water reaches electrical fittings.

Water rarely enters exactly above the stain

Rainwater can travel before it reaches a ceiling. On a tiled roof, a roofer may check for a cracked or shifted tile, a failed ridge cap, or flashing around a pipe penetration. On a metal roof, likely details include sheet overlaps, ridges and fasteners with worn or displaced washers. Water can then follow a rafter or run along the underside of a sheet, so the damp patch indoors may be several metres from the entry point.

A mounting attachment or an earlier repair near the array could be involved, but its location alone doesn’t establish the cause. Roof access can also create damage: a ladder resting on a module frame, repeated foot traffic across tiles or a tool dropped against a panel can leave problems that aren’t obvious from the ground. A rushed sealant patch over a wet or dirty surface can hide the water path without fixing it.

Keep the roofing job and the solar check distinct

A roofer’s job is to diagnose the roof covering and make a sound repair to tiles, flashing, sheet laps or roof penetrations. A solar technician should assess any affected modules, mounting rails, cable supports, conduit entries or inverter equipment. If a roof repair disturbs a mounting point or cable route, both trades may need to coordinate so the roof is watertight and the solar equipment is checked afterwards.

Don’t ask a roofer to disconnect solar connectors or move electrical equipment unless they are qualified to work on that system. Solar DC wiring can remain energised in daylight, so a switch or connector is not a casual DIY fix. Tell the solar technician what the roofer repaired and where; that gives them a useful starting point for checking the affected area.

Clarify roof-related care before choosing a package

“Maintenance included” can mean different things. A visit to inspect solar equipment does not automatically include roof waterproofing, replacement tiles, ceiling repairs or a roofer’s call-out. Before you accept a package, ask whether it covers a visual check near mounting points, electrical checks after roof work, arranging a roofing contractor and a written service record. Have included work, exclusions and separately priced repairs stated plainly.

Inhome Solar Sdn Bhd provides solar system installation and professional maintenance tailored to your package. Ask how the written maintenance scope handles suspected water entry, which checks are included and whether roof repairs need a separate arrangement. For technical service timing, follow the equipment manual and the terms for your specific package; there isn’t one interval that suits every system and site.

Frequently asked questions